ISO 9001 CERTIFIED MANUFACTURER IN-HOUSE GRINDING · COATING · INSPECTION

Five coatings on standard part numbers

Uncoated, TiN, black, bronze and DLC. The coating is part of the series code, so it can be filtered before comparing diameters.

2 min read 206 words Updated 2026-11-06

Coating selection is easier when it is a filter rather than a phone call. Our standard record carries five coating states, and the series prefix tells you which one a part number belongs to.

The states in the catalogue

StateTypical seriesPart numbers on record
Uncoated / polishedDC326, DC326L3,323
TiN (yellow)HDC636, HDCS6363,162
Black coatedDC426, DC426L2,799
Bronze coatedDC836, DC836L1,682
DLC (rainbow)DC336562

Reading the prefix

The prefix also encodes geometry. An L at the end of the base code marks an extended-length variant; HD marks left-hand drilling; S marks a step or special form. HDCS636 is therefore a TiN-coated left-hand step drill, and it is the largest single series in the record with 1,508 part numbers.

A practical comparison

Because the same diameter often exists in several coatings, you can hold the geometry constant and change only the surface:

  • Filter by diameter band, for example 0.90 to 1.10 mm.
  • Compare the DC326, DC426, DC836 and DC336 rows.
  • Ask for one sample of each and run the same programme on the same machine.
A coating change is one variable. Changing coating, flute length and supplier at the same time tells you nothing.

Coating is confirmed in the written quotation, along with the held diameter tolerance for the specific part number.

Data behind the text

Dimensions and part numbers referenced here come from the TONNY production catalogue. Open the series or diameter index to check a specific record before ordering.

Browse series   Diameter index