ISO 9001 CERTIFIED MANUFACTURER IN-HOUSE GRINDING · COATING · INSPECTION

Starting feeds and speeds, and what they assume

Printed page 59 of the 2026-2027 catalogue gives speed and feed by material. Those numbers are a starting point, not a guarantee.

1 min read 184 words Updated 2026-11-06

The 2026-2027 catalogue publishes high-speed drilling parameters for DC326 / DC426L on printed page 59. The table covers twenty diameters and five material groups. Four representative values show the shape of it.

Extract from printed page 59

MaterialD1 mmSpindle rev/minFeed mm/min
Aluminium alloy 50520.1025,000100
Aluminium alloy 50521.0016,0001,200
Stainless SUS304 / 3160.1015,00045
Carbon steel S45C / SS4001.0015,000750
Alloy steel SCM / SKD0.5013,000100
Mould steel NAK / HPM1.007,000210

Printed page 60 adds diameter bands for DC326 / DC326L / DCC326 / DC326XL and for the coated DC426 / DC426L / DC426XL series, including copper alloys, engineering plastics, Ti-6Al-4V, Inconel, aluminium casting and cast iron.

What the numbers assume

  • A rigid setup with a suitable holder. Below 0.3 mm, holder runout dominates tool life.
  • A standard flute length. Extended and extra-long geometries need a reduced feed.
  • The stated coolant condition. Dry drilling in stainless is a different process.
If the edge looks polished rather than cut, the feed is too low. If a thin wall rings, check the assembly before reducing spindle speed.

Change one variable at a time, and record the part number with the result. That is what makes the next order repeatable.

Data behind the text

Dimensions and part numbers referenced here come from the TONNY production catalogue. Open the series or diameter index to check a specific record before ordering.

Browse series   Diameter index