ISO 9001 CERTIFIED MANUFACTURER IN-HOUSE GRINDING · COATING · INSPECTION

What -0.003 mm means on a 0.03 mm drill

The catalogue states a one-sided -0.003 mm diameter tolerance on the DC326 range. Here is how to read that against a real part number.

2 min read 209 words Updated 2026-11-06

The 2026-2027 product catalogue states a diameter range of 0.03 to 3.03 mm and a diameter tolerance of -0.003 mm for the DC326 solid carbide micro drill series. That wording is deliberate.

One-sided, not plus or minus

-0.003 mm means the measured cutting diameter may sit at nominal or up to 0.003 mm below it, but not above. On a hole that will be plated or fitted, an oversized drill is a scrap part; an undersized one can still be corrected or reamed.

Nominal D1Acceptable measured range
0.030 mm0.027 to 0.030 mm
0.500 mm0.497 to 0.500 mm
3.030 mm3.027 to 3.030 mm

At the bottom of the range the tolerance is ten percent of the diameter, which is why measurement method matters as much as the number.

What the report should contain

  • The measured cutting diameter for the lot, not a nominal value copied from the drawing.
  • The part number and its full geometry callout.
  • The carbide batch and grinding programme revision.
Ask which diameter the tolerance applies to. On a step drill there is more than one, and each stage needs its own callout.

The tolerance above is the catalogue statement for DC326. For any other series, confirm the held tolerance on the specific part number in the written quotation rather than assuming it carries across.

Data behind the text

Dimensions and part numbers referenced here come from the TONNY production catalogue. Open the series or diameter index to check a specific record before ordering.

Browse series   Diameter index