ISO 9001 CERTIFIED MANUFACTURER IN-HOUSE GRINDING · COATING · INSPECTION

When a stepped hole needs one pass

1,508 stepped and multi-diameter part numbers are already in the record. Here is how their callouts are written and what they replace.

2 min read 237 words Updated 2026-11-06

A stepped hole normally means two tools, two tool changes and a concentricity risk between them. A step drill grinds both diameters into one body, which is why our largest series is not a standard drill at all.

The scale of the series

HDCS636 has 1,508 distinct part numbers. It is a TiN-coated left-hand step drill family, and almost every entry is a non-standard geometry written for a specific board or component stack.

A typical record looks like this:

D1.45*3.7*120°+1.85*4.0*70°*3*38

Read it as two cutting stages joined by a +: a 1.45 mm stage with a 120° point, then a 1.85 mm stage with a 70° point, on a 3 mm shank and 38 mm overall length.

Why the string is kept verbatim

It is tempting to store only the first diameter. That would make the catalogue easier to sort and useless to an engineer. We keep the full string on the part-number page and mark it as non-standard geometry, with a note to request the dimensioned drawing before ordering.

FieldWhat it controls
Stage diametersHole and counterbore size
Stage lengthsDepth of each step
Point anglesEntry behaviour and exit burr
Shank / overallHolder and reach

Before you design a new one

Search the record by diameter and by series first. With 1,508 existing variants, the geometry you need is often one suffix away from a tool that has already been ground.

Send the two diameters, the two depths and the shank. We check the production record before proposing a new grinding programme.
Data behind the text

Dimensions and part numbers referenced here come from the TONNY production catalogue. Open the series or diameter index to check a specific record before ordering.

Browse series   Diameter index