ISO 9001 CERTIFIED MANUFACTURER IN-HOUSE GRINDING · COATING · INSPECTION
End mills and routers · series HEC

HEC — Solid carbide engraving cutter (not for shrink-fit holders)

6 catalogue part numbers, measured diameters from 0.5 to 1.05 mm, primary coating uncoated.

Diameter range0.5–1.05mm
CoatinguncoatedPrimary coating
Part numbers6on record
Catalogue page—

01Series specification

From the catalogue series record
Series codeHEC
DescriptionSolid carbide engraving cutter (not for shrink-fit holders)
Tooling familyEnd mills and routers
Capability—
Tolerance—
Catalogue diameter range—
Measured diameter0.5–1.05 mm
Primary coatinguncoated
Application—
Catalogue page—
Part numbers on record6

02Part number matrix

6 records
Part numberDescriptionDiameter Flute (mm)Shank (mm)OAL (mm) PointCoatingGeometry
HEC-326-0500Solid carbide engraving cutter (not for shrink-fit holders)0.5————uncoatedD0.50*4.5*3.175*38*2F
HEC-326-1000Solid carbide engraving cutter (not for shrink-fit holders)1————uncoatedD1.00*7*3.175*38*2F
HEC-326-0500-01Solid carbide engraving cutter (not for shrink-fit holders)0.5————uncoatedD0.5*2*3.175*38*2F
HEC-326-0550Solid carbide engraving cutter (not for shrink-fit holders)0.55————uncoatedD0.55*4.5*3.175*38*2F
HEC-326-1050Solid carbide engraving cutter (not for shrink-fit holders)1.05————uncoatedD1.05*7*3.175*38*2F
HEC-336-1000-06-01DLC-coated solid carbide engraving cutter (not for shrink-fit holders)1————DLCD1.00*7*3.175*38*2F

Showing 6 of 6 part numbers in this series. Flute, shank and overall length are catalogue values; the geometry string is reproduced verbatim, including multi-diameter callouts.

03Coatings & geometry

2 coatings on record
uncoated
5 part numbers
In HEC
DLC
1 part numbers
In HEC
Geometry callouts in this series
  • D0.50*4.5*3.175*38*2F · HEC-326-0500
  • D1.00*7*3.175*38*2F · HEC-326-1000
  • D0.5*2*3.175*38*2F · HEC-326-0500-01
  • D0.55*4.5*3.175*38*2F · HEC-326-0550

04Frequently asked questions

What diameter range does this series cover?

The catalogue records a measured range of 0.5–1.05 mm for HEC. Individual diameters are listed in the part matrix above.

Which coatings are available on this series?

The primary coating recorded for the series is uncoated. Across the 6 part numbers on record, the coatings shown in section 03 are the ones actually assigned to those records.

Where does this series sit in the catalogue?

HEC is listed on catalogue page —. Its capability note is: —. Use the part number or the full geometry string when enquiring.

05Adjacent series

End mills and routers

Other series in the same tooling family. Each opens its own specification and part matrix.

Back to all series